Toro titan mx, Руководство по обслуживанию, Страница: 83 / 108

MOWER DECK
6-17 Toro TITAN 2014 Service Manual
6
Leveling the Mower Deck
1. Set anti-scalp rollers to top holes or remove
completely for this procedure.
2. Set the height-of-cut lever to the 3 inch (76mm)
position.
3. Place two 2-5/8” (6.66cm) blocks under each side of
the front edge of the deck, but not under the anti-
scalp roller brackets (Fig. 105).
4. Place two 2-7/8” (7.30cm) thick blocks under the
rear edge of the cutting deck skirt; one on each side
of the cutting deck (Fig. 105).
5. Loosen the adjustment bolts on all four corners so
that the deck is sitting securely on all four blocks
(Fig. 106).
6. Ensure there is tension on all four chains (Fig.106).
7. Tighten the four adjustment bolts (Fig. 106).
Fig. 105 fig. 60 G024426
Fig. 106 fig. 61 G024313
8. Check that blocks fit just snugly under the deck skirt.
Make sure all bolts are tight.
9. Verify that the deck is level by checking the side-to-
side level and front-to-rear blade slope; repeat the
deck leveling procedure if necessary.
A
A
B
B
C
C
D
D
A
B
C
A. Wood block, 2-5/8” (6.66cm) thick
B. Wood block, 2-7/8” (7.30cm) thick
C. Front edge
A. Deck lift arm C. Hook
B. Chain D. Adjustment bolt