Toro TITAN HD 1500, Руководство оператора, Страница: 57 / 88

g027478
Figure 78
Checking the Spark Plug
Important:
Do not clean the spark plug(s).
Always replace the spark plug(s) when it has a
black coating, worn electrodes, an oily film, or
cracks.
If you see light brown or gray on the insulator, the
engine is operating properly. A black coating on the
insulator usually means the air cleaner is dirty.
Set the gap to 0.76 mm (0.03 inch).
g206628
Figure 79
Installing the Spark Plug
g027960
Figure 80
Cleaning the Cooling System
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the air filter from the engine.
4. Remove the engine shroud.
5. To prevent debris entering the air intake, install
the air filter to the filter base.
6. Clean debris and grass from the parts.
7. Remove the air filter and install the engine
shroud.
8. Install the air filter.
Checking the Spark
Arrester
For Machines with a Spark
Arrester
Service Interval: Every 50 hours
WARNING
Hot exhaust-system components may ignite
fuel vapors even after you shut off the engine.
Hot particles exhausted during engine
operation may ignite flammable materials,
resulting in personal injury or property
damage.
Do not refuel or run the engine unless the
spark arrester is installed.
1. Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Wait for the muffler to cool.
4. If you see any breaks in the screen or welds,
replace the arrester.
5. If the screen is plugged, remove the arrester,
shake loose particles out of the arrester, and
clean the screen with a wire brush (soak the
screen in solvent if necessary).
6. Install the arrester on the exhaust outlet.
57