2.
Start the engine again and allow it to run until
it shuts off. When you can no longer start the
engine, it is sufficiently dry.
Preparing the Engine
1.
While the engine is still warm, change the engine
oil; refer to
Changing the Engine Oil (page 19)
.
2.
Disconnect the wire from the spark plug and
remove the ignition key (electric-start model
only).
3.
Remove the spark plug.
4.
Using an oil can, add about 30 ml (1 fl oz), of
motor oil to the engine through the spark-plug
hole.
5.
Slowly pull the starter rope several times to
distribute oil throughout the cylinder.
6.
Install the spark plug but do not connect the wire
to the spark plug. Secure the wire so that it does
not come into contact with the spark plug.
Removing the Machine
from Storage
1.
Unfold the handle; refer to
.
2.
Check and tighten all fasteners.
3.
Remove the spark plug and spin the engine
rapidly using the starter to blow excess oil from
the cylinder.
4.
Inspect the spark plug and replace it if it is dirty,
worn, or cracked; refer to the engine owner’s
manual.
5.
Install the spark plug and tighten it to the
recommended torque of 20 N∙m (15 ft-lb).
6.
Perform any needed maintenance procedures;
refer to
Maintenance (page 18)
.
7.
Check the engine-oil level; refer to
Engine-Oil Level (page 10)
.
8.
Fill the fuel in the fuel tank with fresh fuel; refer
to
Filling the Fuel Tank (page 9)
.
9.
Electric-start model only:
Charge the battery;
refer to
Charging the Battery (page 20)
.
10.
Connect the wire to the spark plug.
27
Содержание TimeMaster 20976
