Toro TimeCutter SS 5000, Руководство оператора

Страница: 18 / 52

5. Try starting the engine; the engine should not crank.
6. Repeat with the other motion-control lever.
7. While sitting on the seat, move the blade-control
switch to O
FF
, and lock the motion-control levers in
the P
ARK
position.
8. Start the engine.
9. While the engine is running, engage the blade-control
switch, and rise slightly from the seat.
Note:
The engine should stop.
10. While sitting on the seat, move the blade-control
switch to O
FF
, and lock the motion-control levers in
the P
ARK
position.
11. Start the engine.
12. While the engine is running, move the motion-control
levers to the center, unlocked position, engage the
blade-control switch, and rise slightly from the seat.
Note:
The engine should stop.
Starting the Engine
Note:
A warm or hot engine may not require choking.
Important:
Do not engage the starter for more than 5
seconds at a time. Engaging the starter motor for more
than 5 seconds can damage the starter motor. If the
engine fails to start, wait 10 seconds before operating the
engine starter again.
g027581
B
C D
E
A
G
F
Figure 11
Operating the Blades
The blade-control switch, represented by a power take-off
(PTO) symbol, engages and disengages power to the
mower blades (
Figure 5 ). This switch controls power to any
attachments that draw power from the engine, including the
mower deck and cutting blades.
18