Storage
Storage Safety
•
Shut off the engine, remove the key, wait for all
movement to stop before you leave the operator’s
position. Allow the machine to cool before
adjusting, servicing, cleaning, or storing it.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Preparing the Traction Unit
1.
Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
the engine, and remove the key.
2.
Thoroughly clean the traction unit, cutting units,
and the engine.
3.
Check the tire pressure; refer to
Tire Pressure (page 40)
.
4.
Check all fasteners for looseness; tighten them
as necessary.
5.
Grease or oil all grease fittings and pivot points.
Wipe up any excess lubricant.
6.
Lightly sand and use touch-up paint on painted
areas that are scratched, chipped, or rusted.
Repair any dents in the metal body.
7.
Service the battery and cables as follows; refer
to
Electrical System Safety (page 39)
:
A.
Remove the battery terminals from the
battery posts.
B.
Clean the battery, terminals, and posts with
a wire brush and baking-soda solution.
C.
Coat the cable terminals and battery posts
with Grafo 112X skin-over grease (Toro Part
No. 505-47) or petroleum jelly to prevent
corrosion.
D.
Slowly charge the battery every 60 days
for 24 hours to prevent lead sulfation of the
battery.
Preparing the Engine
1.
Drain the engine oil from the oil pan and install
the drain plug.
2.
Remove and discard the oil filter. Install a new
oil filter.
3.
Fill the engine with specified motor oil.
4.
Start the engine and run it at idle speed for
approximately 2 minutes.
5.
Shut off the engine and remove the key.
6.
Flush the fuel tank with fresh, clean fuel.
7.
Secure all of the fuel-system fittings.
8.
Thoroughly clean and service the air-cleaner
assembly.
9.
Seal the air-cleaner inlet and the exhaust outlet
with weatherproof tape.
10.
Check the antifreeze protection and add a
50/50 solution of water and ethylene glycol
antifreeze as needed for the expected minimum
temperature in your area.
53
