Toro Reelmaster 5510 Series, Руководство по обслуживанию

Страница: 132 / 662

Installing the Non-Adjustable Fittings (continued)
Fitting Installation Torque Table (continued)
Fitting Dash
Size
Fitting Port Side
Thread Size
(inch(es)—threads
per inch)
Installation Torque
Into Steel Port
Installation Torque Into
Aluminum Port
6 9/16—18 47 to 56 N∙m (34 to
42 ft-lb)
28 to 35 N∙m (20 to
26 ft-lb)
8
3/4—16 79 to 97 N∙m (58 to
72 ft-lb)
48 to 58 N∙m (35 to
43 ft-lb)
10 7/8—14 135 to 164 N∙m (99
to 121 ft-lb)
82 to 100 N∙m (60
to 74 ft-lb)
12 1–1/16—12 182 to 222 N∙m (134
to 164 ft-lb)
110 to 134 N∙m (81
to 99 ft-lb)
14 1–3/16—12 217 to 265 N∙m (160
to 196 ft-lb)
131 to 160 N∙m (96
to 118 ft-lb)
16 1–5/16—12 274 to 336 N∙m (202
to 248 ft-lb)
165 to 202 N∙m (121
to 149 ft-lb)
20 1–5/8—12 335 to 410 N∙m (247
to 303 ft-lb)
202 to 248 N∙m (149
to 183 ft-lb)
Flat From Finger Tight Table
Size FFFT
4 (1/4 inch nominal hose or tubing)
1.00 ± 0.25
6 (3/8 inch) 1.50 ± 0.25
8 (1/2 inch) 1.50 ± 0.25
10 (5/8 inch) 1.50 ± 0.25
12 (3/4 inch)
1.50 ± 0.25
16 (1 inch) 1.50 ± 0.25
Installing an Adjustable Fitting
1. Ensure that all the threads, the sealing surfaces of fitting, and the component
port are free of burrs, nicks, scratches, or unwanted material.
2. To help prevent a hydraulic leak, replace the O-ring when you open the
connection.
g221224
Figure 61
1. Locknut 2. Back-up washer 3. O-ring
Hydraulic System: General Information Page 6–14 Reelmaster ® 5410/5510/5610 Series
15216SL Rev C