1
All Rights Reserved
Printed in the USA
W
2006 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Rear Roller Kit
ProCore
)
648 Aerator
Model No. 09234
Form No. 3355–919 Rev B
Installation Instructions
Installation
1.
Position the machine on a level surface, raise the
coring head, stop the engine, engage the parking brake
and remove the key from the ignition.
2.
Secure the coring head service latch.
3.
Remove the capscrews, washers and nuts securing the
side shields to the coring head (Fig. 1).
1
2
Figure 1
1. Side shield
2. Coring head
4.
Mount the appropriate (R.H. or L.H.) side plate to the
coring head with 3/8 x 1 in. flange head capscrews and
flange nuts. Position side plate as shown in figure 2.
1
Figure 2
1. Side plate (RH shown)
5.
Insert a spring washer onto each end of the roller shaft
(Fig. 3).
6.
Insert a roller arm onto each end of the roller shaft.
Insert a flat washer onto the right hand roller shaft.
Secure the roller shafts to the roller arms with roller
shaft screws. Thread a grease fitting into each roller
shaft screw, if not previously assembled (Fig. 3).
7.
Insert the roller scraper mounting tabs into the slots in
each scraper arm (Fig. 3).
8.
Install the scraper arms to the roller arms with 3/8 x
1–1/4” carriage bolts and 3/8 flange nuts (Fig. 3).
1
2
3
5
6
4
8
7
Figure 3
1. Roller shaft
2. Spring washer
3. Roller arm
4. Flat washer (RH side only)
5. Roller shaft screw
6. Grease fitting
7. Roller scraper
8. Scraper arm
Note:
The roller contacts the turf a few inches behind the
tines and turf hold downs.
