4.
Screw the dipstick filler cap finger-tight onto the
filler neck. It is not necessary to tighten the cap
with a wrench.
Figure 7
1.
Dipstick cap
Check the Rear Axle Lubricant
(Model 30455 Only)
The rear axle is shipped from the factory filled with
SAE 80–90 weight gear lubrication. However, check the
level before the engine is first started and every 50 hours
thereafter. Capacity is 237cl (80 oz).
1.
Position the machine on a level surface.
2.
Clean area around the (3) check plugs, (1) on each
end and (1) in the center (Fig. 8).
3.
Remove the check plugs and make sure lubricant is
up to bottom of hole. If level is low, add enough
lubricant to bring the level up to the bottom of the
check plug holes.
Figure 8
1. Vent/fill
plug
2. Check plug (3)
Figure 9
1. Check/fill
plug
Check Bi-Directional Clutch
Lubricant
(Model 30455 Only) (Fig. 10)
The Bi-directional Clutch is shipped from the factory
filled with Mobil DTE 15 M anti-wear hydraulic fluid.
However, check the level before the engine is first
started and every 50 hours thereafter. Capacity is 8 oz.
Check daily for signs of oil loss.
1.
Position the machine on a level surface.
2.
Remove the check/fill plug from the clutch housing
and make sure lubricant is up to bottom of the hole.
If the level is low, add enough lubricant to bring the
level up to the bottom of the check/fill plug hole.
Note:
Do not use gear lube in the clutch housing.
Figure 10
1. Clutch
housing
2. Check/fill
plug
3. Drain
plug
13
1
1
3
2
1
2
1