Toro Groundsmaster 3300 Series, Руководство оператора

Страница: 62 / 68

Storage
Storage Safety
•
Shut off the engine, remove the key, and wait
for all movement to stop before you leave the
operator’s position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or other appliance.
Preparing the Machine
Important:
Do not use brackish or reclaimed
water to clean the machine.
1. Park the machine on a level surface; engage the
parking brake; shut off the engine; remove the
key; and wait for all movement to stop before
leaving the machine.
2. Thoroughly clean the machine, cutting unit, and
engine.
Important:
Do not use high-pressure water
near the electrical controls or cab seals, as
this may cause damage.
3. Check and adjust the air pressure in the tires;
refer to
Checking the Tire Air Pressure (page
24) .
4. Check the hydraulic lines and hoses; repair
them as necessary.
5. Check the hydraulic-fluid level; refer to Checking
the Hydraulic-Fluid Level (page 58) .
6. Remove, sharpen, balance, and install the
cutting-unit blades.
7. Check for loose fasteners and tighten them as
necessary.
8. Lubricate all grease fittings and apply oil to pivot
points. Wipe clean any excess lubricant.
9. Lightly sand and use touch-up paint on painted
areas that are scratched, chipped, or rusted.
Repair any dents in the metal body.
62