Toro Groundmaster 31900, Руководство по обслуживанию

Страница: 91 / 355

Traction Circuit Component Failure
The traction circuit of the Groundsmaster 3200/3300 machines is a closed
loop system that includes the hydraulic pump and hydraulic wheel motors. If a
component in the traction circuit should fail, unwanted material and contamination
from the damaged component will circulate throughout that traction circuit. This
contamination can damage other components in that circuit. The contamination
must be removed as soon as possible to prevent additional component failure.
The recommended method to remove contamination from the traction circuit is to
temporarily install a Toro high flow hydraulic-fluid filter into the circuit; refer to
High Flow Hydraulic Filter Kit (page 2–18) . If a traction circuit failure is suspect,
the filter should be installed before connecting hydraulic test gauges to test
traction circuit components or after replacing a failed traction circuit component.
The filter will ensure that contaminates are removed from the closed-loop traction
circuit and thus, prevent additional component damage. Refer to
Filtering the
Closed-loop Traction Circuit (page 5–57) for additional information on using the
Toro high flow hydraulic filter.
Note: If traction circuit contamination exists, the traction pump case drain could
allow contaminates to enter the hydraulic tank.
The alternative to using the Toro high flow hydraulic filter kit after a traction circuit
component failure would be to disassemble, drain and thoroughly clean all the
components, the hydraulic tank, and the hydraulic tubes and hoses in the traction
circuit. If any debris remains in the traction circuit and the machine is operated,
the debris can cause additional circuit component failures.
Groundsmaster ® 3200, 3300 and 3310 Page 5–5 Hydraulic System: General Information
19240SL Rev A