Toro Greensmaster TriFlex 3400 Series, Руководство оператора, Страница: 29 / 48

Installing and Removing
the Cutting Units
Installing the Cutting Units
1. Lift up on the foot rest and swing it open, allowing
access to the center cutting unit position (
Figure
31 ).
CAUTION
The foot rest can pinch fingers if it falls
into the closed position.
Keep your fingers clear of the area where
the foot rest seats while it is open.
g014602
Figure 31
1. Footrest—closed 2. Footrest—open
2. Position the cutting unit under the center
suspension arm.
3. With the latches on the suspension-arm bar
pointing up (i.e., open) (
Figure 32 ), push the
suspension arm down so that the bar fits over
the bar across the top of the cutting unit (
Figure
33 ).
g014609
Figure 32
1. Latch—closed position 3. Latch—open position
2. Suspension-arm bar
g014611
Figure 33
1. Suspension-arm bar 2. Cutting-unit bar
4. Close the latches down and around the
cutting-unit bar and lock them in place (
Figure
32 ).
Note:
A “click” can be heard and felt when the
latches are properly locked in place.
5. Coat the spline shaft of the cutting unit motor
with clean grease (
Figure 34 ).
6. Insert the motor into the left side of the cutting
unit (as viewed from the operator's position) and
pull the motor retaining bar on the cutting unit
toward the motor until you hear an audible “click”
from both sides of the motor (
Figure 34 ).
29