Toro Greensmaster eFlex 1800, Руководство по обслуживанию

Страница: 156 / 312

EZ Turn Switch
g202439
Figure 106
1. EZ turn switch 4. Lower handle
2. Washer-head screw (4 each) 5. Switch panel
3. Console cover
The EZ turn switch allows the EZ turn feature to be turned on and off. This
switch is 1 of the several inputs for the TEC. The EZ turn switch is located on
the switch panel (
Figure 106 ).
Note: The EZ turn function is only active when the machine is being operated
with the cutting unit engaged. Also, the EZ turn switch and EZ turn sensor are in
series so both switch and sensor have to be O
N
for the EZ Turn function being
O
N
. If either the switch or the sensor is O
FF
, the EZ Turn function will be O
FF
.
Checking the Operation of EZ Turn Switch
Check the operation of EZ turn switch with the InfoCenter on the console. With
the key switch in the R
UN
position and the InfoCenter in the diagnostics menu,
choose the EZ Turn and ensure that the switch state changes as the switch is
toggled between O
N
and O
FF
. Further EZ turn switch testing is necessary only if
the switch state does not change when using the InfoCenter.
Testing the EZ Turn Switch
1. Park the machine on a level surface and place the traction lever in the
N
EUTRAL
position. Turn the key switch to the O
FF
position and remove the
key from the key switch.
2. Disconnect the battery pack; refer to Connecting the Lithium Battery Pack
(page 5–7) .
3. Remove the console cover from the handle to get access to the EZ turn
switch ( Figure 106 ).
4. Disconnect the EZ turn switch connector from the machine wire harness.
Electrical System: Testing the Electrical Components Page 5–56 Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E