Maintenance
Note:
Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 8 hours
• Check the hydraulic fluid level.
• Change the hydraulic filter.
Before each use or daily
• Check the safety interlock system.
• Check the engine oil level.
• Clean the air intake screen.
• Clean debris from the hydraulic oil cooler (if equiped).
• Check the brakes.
• Inspect the blades.
• Clean the mower deck.
Every 50 hours
• Grease the lift linkage (more often in dirty or dusty conditions).
• Grease the mower deck spindles (more often in dirty or dusty conditions).
• Check spark arrester (if equipped).
• Check the tire pressure.
• Check the hydraulic fluid level.
Every 100 hours
• Change the engine oil. (more often in dirty or dusty conditions)
• Check the battery.
• Check and clean engine cooling fins and shrouds.
• Service the hydraulic oil cooler (in dirty conditions).
• Check the mower deck belt.
• Check the pump drive belt.
• Check the hydraulic hoses.
Every 150 hours
• Inspect the primary filter and air inlet screen.
Every 200 hours
• Change the engine oil filter.
• Check, clean and regap the spark plug.
• Check the clutch.
• Clean the engine oil cooler.
Every 250 hours
• Change the hydraulic filter and hydraulic oil when using Mobil® 1 oil.
Every 300 hours
• Replace the primary air filter. (more often in dusty or sandy conditions)
• Check the inner air filter.
Every 500 hours
• Adjust the caster pivot bearing.
• Change the hydraulic filter and hydraulic oil when using Toro® HYPR-OIL™ 500
hydraulic oil.
Every 600 hours
• Replace the inner air filter.
Every 800 hours
• Grease the front wheel bearings (more often in dirty or dusty conditions).
• Grease the front caster pivots (more often in dirty or dusty conditions).
• Replace the fuel filter.
Before storage
• Paint chipped surfaces.
• Perform all maintenance procedures listed above before storage.
Yearly
• Grease the front caster pivots (more often in dirty or dusty conditions).
• Lubricate the caster wheel hubs
Important:
Refer to your
Engine Operator's Manual
for additional maintenance procedures.
26
Содержание GrandStand 74583
Страница 64: ...Schematics g017891 COOLER Hydraulic Schematic Rev A 64...
Страница 65: ...g018109 Electrical Schematic Rev A 65...
Страница 66: ...Notes 66...
Страница 67: ...Notes 67...
