Toro GrandStand 74549, Руководство оператора

Страница: 43 / 68

Note:
High pressure and over-speeding the fan may
cause fan failure. Use care with compressed air to avoid
over-speeding the electric fan. Never direct a pressure washer
on the electric fan.
Servicing the Hydraulic Oil
Cooler (52 and 60 inch Mower
Models Only)
Service Interval: Every 100 hours—Service the hydraulic oil
cooler (in dirty conditions) (if equipped).
1. Keep the hydraulic oil cooler free of debris by cleaning
the fins.
2. Blow the hydraulic oil cooler fins to clean away any
loose dry debris.
3. Flush the cooler fins clean with water from a water hose
to clean away any dirt. A soft brush (i.e. toothbursh)
with a soap and water solution may be used to clean
the cooler. Do not use a pressure washer.
Note:
High pressure and over-speeding the fan may
cause fan failure. Use care with compressed air to avoid
over-speeding the electric fan. Never direct a pressure
washer on the electric fan.
g017913
2 3
1
Figure 64
1. Hydraulic tank 3. Hydraulic oil cooler
2. Bolts
Brake Maintenance
Servicing the Brake
Before each use, check brakes on both a level surface and
slope.
Always set the parking brake when you stop the machine
or leave it unattended. If the parking brake does not hold
securely, an adjustment is required.
Checking the Parking Brake
Service Interval: Before each use or daily
1. Park the machine on a level surface, disengage the PTO.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Release the brake. The brake bars should lift off the
tires and the hand lever should travel forward to the
end of the slot in the control panel. Adjust the brake
if needed.
4. Engage the brake lever until the brake bars first contact
the tire (Figure 65).
5. Measure the gap from the front of the hand lever to the
end of the slot in the control panel when the brake bar
contacts the tire. This measurement needs to be 3/4
inch (19 mm). Adjust the brake if needed (Figure 65).
43