Toro 74408 Z334 Z Master, Руководство оператора

Страница: 24 / 52

Figure 23
Figure 24
Lubricating the Caster Wheel
Hubs
Service Interval: Yearly
Note:
When performing this procedure, the old seals
will need to be replaced with new seals. Contact an
Authorized Service Dealer for the correct seals.
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Raise the front of the machine and support it with
jack stands.
4. Remove then nut and bolt holding the caster wheel
to the front caster fork (Figure 25).
5. Remove the seal guard from the wheel hub
(Figure 25).
Figure 25
1. Caster fork 4. Caster wheel
2. Bolt 5. Nut
3. Seal guard
6. Remove one of the spacer nuts (with wrench flats)
from the axle (Figure 27).
Note:
Thread locking adhesive has been applied
to the spacer nuts.
7. Remove the axle without removing the opposite
spacer nut (Figure 27).
8. Remove the seals and inspect the bearings for wear
or damage. Replace the bearings if needed.
9. Pack the bearings with general purpose grease.
10. Insert the bearing and a new seal into the wheel
(Figure 27).
Note:
Do not install the nut all the way onto the
axle.
11. If both spacer nuts were removed from the axle,
apply thread locking adhesive to the spacer nut.
Install the spacer nuts onto the axle leaving an 1/8
inch (3mm) of the nut past the axle (Figure 26).
24