Toro 726TE Power Max, Руководство оператора

Страница: 16 / 24

16
3329-767
Checking and Adjusting the
Auger/Impeller Cable
Check and adjust the auger/impeller cable after the
first 2 operating hours, then annually thereafter.
1. Remove all the
fasteners on the front
engine cover (A), but do
not try to remove the
cover.
m-7090
A
2. Remove the
fasteners on the
left belt cover, then
remove the cover
in the sequence
shown.
m-7138
1
2
3. Remove the fasteners on the right belt cover,
then remove the cover in the sequence shown.
m-7162
1
2
m-7163
3
4. With the auger/impeller lever disengaged, ensure
that the gap between the auger clutch assembly and
the tab (A) is 1/16 inch (1.5 mm).
m-6963
1/16 in. (1.5 mm)
A
A
5. If the auger/impeller cable is not properly
adjusted, do the following steps:
6. Loosen the jam
nut (A).
7. Loosen or tighten
the turnbuckle (B) that
adjusts the tension on
the cable.
Note: Ensure that
the cable does not
twist.
m-6903
A
B
8. Adjust the turnbuckle until you obtain the proper
gap.
9. Tighten the jam nut.
10. Insert the left belt cover into place.
11. Insert the right belt cover into place.
12. Secure the front engine cover to the rear engine
cover using the fasteners previously removed.
13. Secure the left and right belt covers using the
fasteners previously removed.
14. If the auger/impeller cable is properly adjusted but
a problem remains, contact an Authorized Service
Dealer.