Toro 46452, Руководство оператора

Страница: 6 / 36

Setup
1
Removing the Machine from the Pallet
No Parts Required
Procedure
The attachment is shipped vertically on the pallet. Perform the following instructions to remove it from the pallet.
DANGER
The attachment is unstable and could swing when lifted, injuring anyone beneath it or around it.
• Refer to the lifting machine operator’s manual to ensure that it is rated to lift the attachment.
• Ensure the lift height is kept to a minimum and only high enough to remove the shipping
material.
• Do not crawl under the attachment.
The machine is shipped vertically on the pallet. Use the following instructions to remove it from the pallet.
Note:
Use 2 different machines at the same time to lift the machine and set it in operating position.
1. Place the pallet on level ground.
2. Mount lifting cables at the lifting points shown in Figure 3 and Figure 4 .
Note:
Refer to the lifting machine Operator's Manual to ensure that it is rated to lift the attachment.
3. Raise the attachment (including the pallet) 50 mm (2 inches) from the ground.
4. Gently lower the attachment in a controlled way as shown in Figure 4 until it is placed on the ground.
5. Remove the hitch pins.
6. Remove the pallet.
7. Install the hitch pins.
6