Troubleshooting
Problem
Possible Cause
Corrective Action
1. There is an obstacle(s) between the
knives
1. Remove the obstacle(s).
2. The knives are worn or broken.
2. Replace with new knives.
The machine vibrates.
3. The rotor is unbalanced.
3. Balance the rotor.
1. The working depth is not correct.
1. Adjust the working depth properly.
2. The subsoil is too hard.
2. Lower the driving speed or pass over
the soil more than once.
The working depth is not achieved.
3. The driving speed is too high.
3. Lower the driving speed.
1. The driving speed is too high.
1. Lower the driving speed.
The soil is too coarse while processing.
2. The soil is too wet.
2. Wait for better conditions.
1. The soil is too wet.
1. Wait for better conditions.
2. There is an obstacle(s) between the
knives
2. Remove the obstacle(s).
3. The driving speed is too high.
3. Lower the driving speed.
The rotor is jammed.
4. There is too much overgrowth.
4. Cut the overgrowth.
1. The V-belts that drive the rotor slip.
1. Thighten the V-belts.
The rotor does not turn.
2. The machine is adjusted too deep.
2. Adjust the machine depth.
1. The driving speed is too high.
1. Lower the driving speed.
The transport belt cannot handle the
quantity of material.
2. Transport belt turns too slowly.
2. Increase the oil flow of the tractor.
1. There is no hydraulic flow.
1. Check the hydraulic connections.
The transport belt moves slowly or does
not move.
2. The transport belt slips.
2. Tighten the transport belt.
32
Содержание 46452
Страница 7: ...g357840 Figure 3 1 Lifting point 2 Rear roller g348382 Figure 4 1 Lifting point 7...
Страница 21: ...g347982 Figure 27 1 Hairpin cotter 3 2 Hitch pin 3 21...
Страница 33: ...Notes...
Страница 34: ...Notes...
