Toro 39926, Руководство оператора

Страница: 23 / 32

Maintenance
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 2 hours
• Inspect the traction cable and adjust it if necessary.
• Inspect the auger/impeller cable and adjust it if necessary.
Yearly
• Check the skids and the scraper and adjust them if necessary.
• Inspect the traction cable and adjust or replace it if necessary.
• Inspect the auger/impeller cable and adjust or replace it if necessary.
• Check the auger-gearbox oil and add oil if necessary.
• Lubricate the hex shaft.
Yearly or before storage
• Check the air pressure in the tires and inflate them to 116 to 137 kPa (17 to 20 psi).
• Have an Authorized Service Dealer inspect and replace the traction-drive belt and/or
the auger/impeller drive belt, if necessary.
Preparing for Maintenance
1. Move the machine to a level surface.
2. Stop the machine, remove the electric-start key,
wait for all movement to stop, and remove the
battery pack from the machine before adjusting,
servicing, cleaning, or storing the machine.
Checking and Adjusting the
Skids and Scraper
Service Interval: Yearly—Check the skids and
the scraper and adjust them if
necessary.
Check the skids and the scraper to ensure that the
auger does not contact the paved or gravel surface.
Adjust the skids and the scraper as needed to
compensate for wear.
1. Check the tire pressure; refer to 7 Checking the
Tire Pressure (page 12) .
2. Loosen the nuts that secure both skids to the
auger sides until the skids slide up and down
easily.
g019046
Figure 28
1. 3 mm (1/8 inch)
Important:
The auger blades must be
supported above the ground by the skids.
23