Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
Completion kit (sold separately)
1
Install a completion kit.
2
Castor wheel assembly
2
Install the castor wheel assemblies.
Lift-arm, right
1
Lift-arm, left
1
Lift cylinder pin
2
Cylinder carriage bolt
2
3
Cylinder flange nut
2
Install the lift arms.
Thrust washer
4
Clevis pin
4
Hairpin cotter
2
Height-of-cut collar
2
Clevis pin
2
4
Hairpin cotter
2
Install the cutting units.
5
No parts required
–
Connect the hydraulic drive.
6
No parts required
–
Grease the machine.
Media and Additional Parts
Description
Qty.
Use
Parts Catalog
1
Operator's Manual
1
Read the contents of these materials and store them in
a safe location.
DANGER
If the engine is started and you have not correctly
connected the hydraulic hoses, serious injury can
result.
You must make sure that the hydraulic hoses are
correctly connected or that blanking plugs have
been fitted before starting the engine and engaging
the cutting unit.
Note:
Determine the left and right sides of the machine
from the normal operating position.
1
Installing a Completion Kit
Parts needed for this procedure:
1
Completion kit (sold separately)
Procedure
Install one of the following 62 inch or 72 inch completion kits
to the base deck using the instruction provided in the kit:
•
Model 30648, 62 inch Rear Discharge
•
Model 30306, 62 inch Guardian
•
Model 30649, 72 inch Rear Discharge
•
Model 30304, 72 inch Guardian
7
