Figure 101
1.
Floor plate
10. Remove the roll pin and loosen the two capscrews
securing the drive shaft to the gearbox shaft
(Figure 102). Slide the drive shaft off the gearbox
shaft.
Figure 102
1.
Pressure hose
4.
Cable tie
2.
Tank hose
5.
Bolts
3.
Hose cover
6.
Roll pin
11. Disconnect the tank hose from the control valve
(Figure 103). Cap the hose and fitting with a cap
and plug. Pull the tank hose back toward the rear of
the frame.
Figure 103
1.
Control valve
3.
Pressure hose
2.
Tank hose
12. Disconnect the pressure hose from the control
valve (Figure 103). Cap the hose and fitting with a
cap and plug. Pull the hose back toward the rear of
the frame.
13. Lower the floor jack until the deck vertical support
assemblies are supporting the rear of the deck frame
and the rear bumper is lightly supported.
14. Carefully remove the bolts (3/4 inch), washers and
nuts that secure the deck frame to the rear frame (3
on the left side and 2 on the right side) (Figure 104).
Retain 4 of the bolts for re-installation and store the
remaining for summer change over.
Note:
The floor jack can be raised or lowered to
ease removal of the bolts. Lower the floor jack
completely once the bolts are removed.
Figure 104
1.
3 mounting bolts (3/4 inch), washers and nuts (Left side)
37
