G009487
1
2
1
3
Figure 65
1.
Bolt
3.
Power point shield
2.
Power point assembly
7. Slide the power point shield up over power point
while aligning the shield hole with the hole in the
power point assembly plate (Figure 65). The longer
end of the shield is to point forward to protect the
power point.
8. Secure the shield to the cab with the bolt previously
removed.
10
Making the Final Connections
and Checking the Operation
No Parts Required
Procedure
1. Tighten the bolts and nuts securing the cab mount
supports to the ROPS posts.
2. Connect the cab pressure and return heater hoses
to the quick couplers on the rear frame mount
(Figure 66).
Figure 66
1.
Return hose
2.
Pressure hose
3. Remove the cap and plug the cab wire harness
connector into the harness on the rear frame mount
(Figure 67).
Figure 67
1.
Cab wire harness
connector
2.
Harness connector on the
rear frame mount
4. Reinstall the back panel to the cab.
Note:
Reinstall the doors and windows (if removed)
and secure door closer to the cab door bracket.
5. Fill the radiator. Refer to the
Operator’s Manual
for
fluid specifications.
26
