Figure 62
1.
Front cover
9
Mounting the Cab
Parts needed for this procedure:
4
Rubber cab mount (supplied with cab model 30371)
4
Bolt (1/2 x 3 inches) (supplied with cab model 30371)
4
Washer-Steel (1/2 x 2–1/2 inches) (supplied with cab
model 30371)
4
Washer-rubber (1/2 x 2–1/2 inches) (supplied with cab
model 30371)
4
Nut (1/2 inch) (supplied with cab model 30371)
2
Corner mat (supplied with cab model 30371)
1
Power Point Shield
Procedure
1. Remove the clip securing the door closer socket to
the door bracket ball (Figure 63).
Figure 63
1.
Cab door bracket
3.
Clip
2.
Door closer
Note:
The cab doors and windows may be removed
to ease installation, decrease the lifting weight and to
prevent possible damage.
2. Remove the fasteners securing the cab to the
shipping pallet.
3. Insert a rubber cab mount at the front and rear
mounting locations (Figure 64).
4. Using a suitable overhead hoist, carefully lift the
cab into position on the machine. Use caution not
to damage cab roof, controls, hoses or electrical
connectors.
5. At each mounting point, secure the cab to the
machine with a bolt (1/2 x 3 inches), steel washer
(1/2 x 2–1/2 inches), rubber washer (1/2 x 2–1/2
inches) and nut (1/2 inch) (Figure 64). Tighten the
bolts until the rubber mounts are compressed to a
thickness of 7/8 inch (2.2 cm).
Figure 64
1.
Rubber mount
2.
0.875 inch (2.2 cm)
6. Remove the bolt securing the power point assembly
to the right front corner of the cab frame (Figure 65).
25
