Figure 44
1.
Drive shaft
2.
Frame tube
6. Route the hoses as follows:
•
Route the pressure hose under the lift cylinder
and between the cylinder mounting brackets to
the valve (Figure 45).
•
Route the tank hose along side the PTO shaft
to the valve (Figure 45).
Note:
To emphasis the hose routing, the hoses
are shown without the hose covers installed.
Figure 45
1.
Tank hose
2.
Pressure hose
7. Connect the drive shaft to the gear box shaft in the
winter frame and torque the bolts (5/16 inch) to
175-225 in-lb (20 to 25 N
⋅
m). Install the roll pin
Figure 46
1.
Pressure hose
4.
Cable tie
2.
Tank hose
5.
Bolts
3.
Hose cover
6.
Roll pin
8. With the winter frame against the rear frame, raise
the floor jack enough to remove the summer drive
tires (Figure 47). Install the winter tires with 2 lug
nuts per side.
Figure 47
1.
Summer drive tire
9. Adjust the floor jack to line up the 1.00 inch holes
in the frame and install a coupler pin on each side
(Figure 48).
20
