Toro 30280, Руководство оператора

Страница: 16 / 64

Figure 5
1. Parking brake lever (in the
released position)
2. Parking brake lever (in the
engaged position)
Releasing the Parking Brake
Push the parking brake lever forward.
Starting and Stopping the
Engine
Starting the Engine
1. Connect the wires to the spark plugs.
2. Open the fuel valve.
3. Move the speed control lever to neutral.
4. Set the neutral locks.
5. Set the parking brake.
6. Move the throttle control to fast and move the
choke lever to the on position before starting a
cold engine (Figure 6).
Note:
A warm or hot engine may not require
choking. To start a warm engine, move throttle
control to the fast position.
Figure 6
1. Ignition switch 3. Choke
2. Throttle lever
7. Turn the ignition key to the start position to
energize the starter. When the engine starts,
release the key.
Note:
Do not engage the starter for more
than 5 seconds at a time. If the engine fails to
start, allow for a 15 second cool-down period
between attempts. Failure to follow these
instructions can burn out the starter motor.
8. When engine starts, move the throttle control
between the fast and slow position and move
the choke lever to the off position. Allow the
engine to warm up and then move the throttle
control to the fast position.
Stopping the Engine
1. Move drive levers to neutral and set neutral
locks.
2. Move the throttle lever to slow (Figure 6).
3. Move the speed control lever to neutral and
release the OPC levers to disengage the mower.
4. If the engine has been working hard or is hot,
let the engine idle for 30 to 60 seconds before
turning the engine off.
5. To stop the engine, turn the ignition key to off.
Important:
Make sure fuel shut off valve
is closed before transporting or storing
machine, as fuel leakage may occur. Before
storing machine, pull wire off spark plug(s)
to prevent possibility of accidental starting.
Operating the Neutral Locks
Always set the neutral lock when you stop
the machine. Set the parking brake if it is left
unattended.
16