Revision 1 02-24-2021
Toro Form No 3445-719 Rev A
Tool Inspection Process
Check the operating hours on the hour meter, then perform the necessary maintenance procedures as specified in the following table (for complete
procedures, refer to the
Operator’s Manual
):
Maintenance Service Interval
Maintenance Procedure
After each use
• Check for missing or damaged parts, especially safety devices, shields, guards, and decals; ensure that the
machine starts and operates properly.
• Tighten all fasteners.
• Check the engine oil level.
• Grease the machine.
• Check the air filter cyclone housing for a layer of dirt in the bottom of the container. Clean it if dirty.
• Check the drive belt tension.
• Check the condition of the teeth; rotate or replace any that are worn or damaged; torque the nuts for all teeth.
• Remove debris from the machine.
After the first 25 hours
Change the engine oil.
Every 25 hours
Check the drive belt tension.
Tool Rental Center
Tool Turn Guide
SGR-6 Stump Grinder
Model No.
22600HD—316000001 and Up
Supplier Technical Support #:
888-384-9939 (US and Canada)
Supplier Website:
www.Toro.com
PURPOSE
Follow the directions below to maintain this tool.
SAFETY
Refer to the product Operator’s Manual for complete safety information.
