Toro 22327, Руководство оператора

Страница: 38 / 60

Jump-Starting the Machine
WARNING
Contact with hot surfaces may cause personal
injury.
Keep hands, feet, face, clothing and other body
parts away the muffler and other hot surfaces.
WARNING
Jump-starting the battery can produce gasses that
can explode.
Do not smoke near the battery, and keep sparks and
flames away from battery.
1. Open the hood, secure the prop rod, and remove the
left side screen.
2. Remove the cover from the jump post ( Figure 54 ).
g033902
Figure 54
1. Jump post
3. Connect an end of the positive (+) jumper cable to the
jump post (
Figure 54 ).
4. Connect the other end of the positive (+) jumper cable
to the positive terminal of the battery in the other
machine.
5. Connect an end of the negative (-) jumper cable to the
negative post of the battery in the other machine.
6. Connect the other end of the negative (-) jumper cable
to a ground point, such as an unpainted bolt or chassis
member.
7. Start the engine in the other machine. Let it run a few
minutes, then start your engine.
8. Remove the cables in the reverse order of connection.
9. Install the cover to the jump post.
Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows, check the
component/circuit for a malfunction or a short.
Figure 55
illustrates the fuse block and identifies the fuse positions.
g029409
Figure 55
1. Fuse (20 A) 3. Fuse (10 A)
2. Fuse (15 A) 4. Fuse (7.5 A)
Note:
If the machine does not start, either the main circuit
or the control panel/relay fuse could be blown.
There is also a fuse (50 A) located on the right side of the
machine. Raise the loader arms, install the cylinder lock, and
remove the right access cover. The fuse is located just inside
the frame.
g205353
Figure 56
1. Bolt 3. Fuse location
2. Right access cover
38