Toro 22306, Руководство оператора

Страница: 22 / 52

Using Attachments
Important:
If you are using an attachment
with a serial number of 200999999 or earlier,
the manual for the attachment may contain
information specific to the use of the
attachment with other Dingo models, such as
settings for the flow divider control and speed
selector lever and the use of a counterweight
on the traction unit. These systems are built
into the Dingo TX, and you should ignore any
references to them.
Installing an Attachment
Important:
Use only Toro-approved
attachments. Attachments can change the
stability and the operating characteristics of
the traction unit. The warranty of the traction
unit may be voided if used with unapproved
attachments.
Important:
Before installing the
attachment, ensure that the mount plates are
free of any dirt or debris and that the pins
rotate freely. If the pins do not rotate freely,
grease them.
1. Position the attachment on a level surface with
enough space behind it to accommodate the
traction unit.
2. Start the engine.
3. Tilt the attachment mount plate forward.
4. Position mount plate into the upper lip of the
attachment receiver plate (Figure 14).
Figure 14
1. Mount plate 2. Receiver plate
5. Raise the loader arms while tilting back the
mount plate at the same time.
Important:
The attachment should be
raised enough to clear the ground, and the
mount plate should be tilted all the way
back.
6. Stop the engine.
7. Engage the quick attach pins, ensuring that
they are fully seated in the mount plate
(Figure 15).
Important:
If the pins do not rotate to
the engaged position, the mount plate
is not fully aligned with the holes in the
attachment receiver plate. Check the
receiver plate and clean it if necessary.
Figure 15
1. Quick attach pins (shown
in engaged position)
3. Engaged position
2. Disengaged position
If you do not fully seat the quick attach
pins through the attachment mount
plate, the attachment could fall off of the
traction unit, crushing you or bystanders.
Ensure that your quick attach pins are
fully seated in the attachment mount
plate.
22