Toro 22303 Dingo 320-D, Руководство оператора

Страница: 26 / 40

If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect the negative battery cable before you do
any maintenance.
Premaintenance
Procedures
Removing the Front Access
Cover
1. Raise the loader arms and install the cylinder
locks.
Note:
In the case that you need to remove
the front access cover without raising the
loader arms, be very careful not to damage the
cover or hydraulic hoses as you maneuver the
cover out from under the arms.
2. Stop the engine and remove the key.
3. Release the two locking tabs (Figure 21).
Figure 21
1. Front access cover 2. Locking tabs
4. Pull the cover off of the traction unit
(Figure 21).
5. When finished, replace the front access cover
and secure it with the two locking tabs.
Opening the Rear Access
Cover
1. Stop the engine and remove the key.
2. Release the two locking tabs on top of the rear
access cover (Figure 22).
Figure 22
1. Rear access cover
3. Bolt
2. Locking tabs
3. Remove the bolt located next to the right
locking tab (Figure 22).
4. Grasping the handle, pull the cover up and
back to swing it open (Figure 22).
5. When finished, close the rear access cover by
swinging it up and seating it in place.
6. Secure it with the two locking tabs and bolt.
Lubrication
Greasing the Traction Unit
Grease all pivot joints every 8 operating hours and
immediately after every washing.
Grease Type: General-purpose grease.
1. Lower the loader arms and stop the engine.
Remove the key.
2. Clean the grease fittings with a rag.
3. Connect a grease gun to each fitting (Figure 23
and Figure 24).
26