Toro 2226, Руководство оператора

Страница: 32 / 108

Right Joystick
The joystick controls vary depending on the control mode you select when powering up the machine. There are
2 control modes: Drill Mode I and Drill Mode II; refer to the Control-Select Screen in the
Software Guide for
information on setting the control modes.
g226146
Figure 33
Right Joystick
1. Turn the mud on or off 4. Open and Close the rear wrench 7. Set the auto drill on or off
2. Increase the mud flow momentarily 5. Open and close the front wrench 8. Set the carriage to high speed
3. Decease the mud flow momentarily 6. Rotate the wrench clockwise and
counter clockwise (make and break
rotation) 9. Max flow of mud
Right Joystick — Drill Mode I
g226144
Figure 34
Right Joystick — Drill Mode I
1. Thrust the carriage forward 3. Pull the carriage back
2. Rotate the drill spindle
counter clockwise 4. Rotate the drill spindle
clockwise
Right Joystick — Drill Mode II
g226144
Figure 35
Right Joystick — Drill Mode II
1. Thrust the carriage forward 3. Pull the carriage back
2. No action 4. No action
32