
Form No. 3376-266 Rev A
Rear Roller Extension Kit
Greensmaster
®
DPA Reel Mowers
Model No. 125-5180
Installation Instructions
Installation
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals
known to the State of California to cause cancer,
birth defects, or reproductive harm.
1.
Raise the rear of the cutting unit and place a block
under the bedknife.
2.
Remove and discard the 2 nuts securing each roller.
Retain the shim, but discard the bolts, roller spacer, and
roller retainer (Figure 1).
Figure 1
1.
Mounting nuts
4.
Roller spacer
2.
Side plate mounting flange
5.
Roller retainer
3.
Shim
3.
Install the loose parts and previously removed shim
as shown in Figure 2 or Figure 3, depending on the
desired height-of-cut.
4.
Adjust to the desired height-of-cut, and tighten the
height of cut arm mounting fasteners.
Figure 2
Height-of-cut between 3–25 mm (1/8–1 inch)
1.
Flange-head nut
5.
Roller retainer
2.
Shim
6.
Long bolt
3.
Set screw
7.
Short bolt
4.
Roller spacer
© 2013—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3376-266* A