Form No. 3365-152 Rev A
Accessory Wiring Kit
Groundsmaster
®
4000-D and 4100-D Series Traction Unit
Model No. 115-8492
Installation Instructions
Installation
For Models 30412 and 30413
1. Position the machine on a level surface, lower the
cutting unit, stop the engine, engage the parking
brake and remove the key from the ignition.
2. Disconnect the negative battery cable from the
battery.
3. Remove the control panel cover (Figure 1) to gain
access to the fuse block area.
G009954
1
Figure 1
1.
Control panel cover
4. Locate the holes under the decal on the top of the
control console. Remove the decal material covering
the holes (Figure 2).
5. Clean the mounting surface and apply the control
decal over the holes on the control console (Figure 2).
6. Loosely mount a toggle switch in each hole with the
washers and nuts supplied (Figure 2).
G009955
1
2
3
Figure 2
1.
Console decal
3.
Harness connectors
2.
Toggle switches
7. Plug the (2) connectors from the accessory wire
harness onto the toggle switch terminals (Figure 2).
8. Remove the (3) screws and nuts securing the fuse
block to the inside of the control console (Figure 3).
9. Move the fuse block down to the next set of
mounting holes and reinstall with the screws and
nuts previously removed (Figure 3).
G009956
2
1
Figure 3
1.
Fuse block
2.
Grounding bolt
© 2010—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
