W
2005 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Contact us at www.Toro.com
All Rights Reserved
Printed in the USA
Original Instructions (EN)
Replacement Belt Kit
for Multi Pro
)
1200 and 1250 Turf Sprayers
Model No. 108-3654
Form No. 3353-475 Rev A
Installation Instructions
Note:
Determine the left, right, front, and rear sides of the machine while seated in the normal operating position.
Note:
A 5/8 inch crow foot wrench with a 9 inch or longer ratchet extension or equivalent tools are recommended for the
installation of this kit.
Loose Parts
Note:
Use the chart below to identify parts for assembly.
DESCRIPTION
QTY.
USE
Belt, drive
1
Install the belt
Installation instructions
1
Read before installing the kit.
Preparing the Machine
1.
Position the sprayer on a level surface, set the parking
brake, stop the pump, stop the engine, and remove the
ignition key.
2.
Empty the contents of the tank. Refer to the
Operator’s
Manual
for more information.
Chemicals are hazardous and can cause personal
injury.
•
Read the directions on the chemical labels
before handling the chemicals and follow all
manufacturer recommendations and
precautions.
•
Keep chemicals away from your skin. Should
contact occur, wash the affected area thoroughly
with soap and clean water.
•
Wear goggles and any other protective
equipment recommended by the chemical
manufacturer.
Caution
3.
Remove the front agitation hose on the tank to allow
access to drive belt. Use caution to avoid exposure to
residual chemicals in the hose when removing it
(Fig. 1).
1
2
Figure 1
1. Primary clutch
2. Agitation hose
4.
Rest the agitation hose above the heat shield while
installing the new belt.
Installing the Belt
1.
Use a 5/8 inch crow foot wrench with a 9 inch extension
or an equivalent to loosen the bolts securing the belt
guides to the engine (Fig. 2).
2.
Rotate the upper belt guide upward to a vertical position
so that it will not interfere with any parts (Fig. 2).
