Toro 108-2639 Скачать руководство пользователя страница 1

Form No. 3353-411 Rev A

Blower Liner Kit

For Z400 and Z500 Twin and Triple Baggers

Model No. 108–2639
Model No. 108–2640

Installation Instructions

Installation

Loose Parts

Use the chart below to verify that all parts have been shipped.

Step

Description

Qty.

Use

Blower liner

1

Fanged elevator bolt

5

Flat washer

5

1

Locknut

5

Replacing the Blower Liner

Step

1

Parts needed for this step:

1

Blower liner

5

Fanged elevator bolt

5

Flat washer

5

Locknut

Procedure

1. Disengage the PTO, set the parking brake, and

chock or block the drive wheels.

2. Turn off the engine, remove the key, and wait for all

moving parts to stop before leaving the operating
position.

3. Remove the five bolts that hold the blower liner

to the blower (Figure 1 andFigure 2). Discard the
hardware.

4. Pull the liner out of the blower (Figure 1).

Note:

Do not use your hands to remove the

debris.

5. Remove any debris from the blower.

6. Slide the new liner around the blower impeller.

The new liner and fanged elevator bolts
may have sharp edges which could cut your
hands or cause slivers. Wear gloves when
handling them.

7. Secure the liner to the rear of the blower with 3

fanged elevator bolts (5/16 x 1 inch), flat washers
and locknuts (5/16 inch) (Figure 1).

Figure 1

1. Blower

4. Washer, 5/16 inch

2. Liner

5. Locknut, 5/16 inch

3. Fanged elevator bolt, 5/16

x 1 inch

© 2005—The Toro® Company

8111 Lyndale Avenue South

Bloomington, MN 55420

Register at www.Toro.com.

Original Instructions (EN)

Printed in the USA.

All Rights Reserved

Отзывы: