
Storage
Storage Safety
•
Let the engine cool before storing the machine.
•
Do not store the machine or fuel near flames or
drain the fuel indoors.
Storing the Machine
Service Interval:
Every 200 hours—Inspect the
service and parking brakes.
Every 400 hours—Visually inspect the brakes
for worn brake shoes.
After the first 50 hours
Every 600 hours/Yearly (whichever comes first)
1.
Park the machine on a level surface, engage the
parking brake, shut off the engine, and remove
the key.
2.
Clean dirt and grime from the entire machine,
including the outside of the engine cylinder head
fins and blower housing.
3.
Inspect the brakes; refer to
Brake-Fluid Level (page 51)
.
4.
Service the air cleaner; refer to
.
5.
Seal the air cleaner inlet and the exhaust outlet
with weatherproof tape.
6.
Grease the machine; refer to
Bearings and Bushings (page 38)
.
7.
Change the engine oil and filter; refer to
Changing the Engine Oil and Filter (page 42)
.
8.
Flush the fuel tank with fresh, clean diesel fuel.
9.
Secure all fuel system fittings.
10.
Check the tire pressure; refer to
Tire Pressure (page 20)
.
11.
Check anti freeze protection and add a 50/50
solution of water and anti freeze as needed for
expected minimum temperature in your area.
12.
Remove the battery from the chassis, check
the electrolyte level, and charge it fully; refer to
Servicing the Battery (page 45)
.
Note:
Do not connect the battery cables to the
battery posts during storage.
Important:
The battery must be fully
charged to prevent it from freezing and being
damaged at temperatures below 0°C (32°F).
A fully charged battery maintains its charge
for about 50 days at temperatures lower
than 4°C (40°F). If the temperatures will be
above 4°C (40°F), check the water level in the
battery and charge it every 30 days.
13.
Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged.
14.
Paint all scratched or bare metal surfaces.
Paint is available from your Authorized Service
Dealer.
15.
Store the machine in a clean, dry garage or
storage area.
16.
Cover the machine to protect it and keep it clean.
61
Содержание 07385TC Workman HDX-D
Страница 39: ...g010359 Figure 32 39...