Toro 07059LT, Руководство оператора

Страница: 17 / 60

Adding Fuel
Recommended Fuel
Type Unleaded gasoline
Minimum octane rating 87 (US) or 91 (research
octane; outside the US)
Ethanol No more than 10% by volume
Methanol None
MTBE (methyl tertiary butyl
ether) Less than 15% by volume
Oil Do not add to the fuel
Use only clean, fresh (no more than 30 days old), fuel
from a reputable source.
Important:
To reduce starting problems, add fuel
stabilizer/conditioner to fresh fuel as directed by
the fuel-stabilizer/conditioner manufacturer.
Refer to your engine owner’s manual for additional
information.
Filling the Fuel Tank
The fuel-tank capacity is approximately 18.9 L (5 US
gallons).
1. Park the machine on a level surface.
2. Shift the transmission to the N
EUTRAL
position.
3. Engage the parking brake.
4. Shut off the machine and remove the key.
5. Clean the area around the fuel-tank cap ( Figure
14 ).
g033956
Figure 14
1. Empty 4. Full
2. Half full
5. Fuel-tank cap
3. Needle 6. Fuel gauge
6. Remove the fuel-tank cap.
7. Fill the tank to about 25 mm (1 inch) below the
top of tank (bottom of the filler neck).
Note:
This space in the tank allows fuel to
expand. Do not overfill the fuel tank.
8. Install the fuel-tank cap securely.
9. Wipe up any spilled fuel.
Breaking in a New Machine
Service Interval: After the first 100 hours—Perform
the guidelines for breaking in a new
machine.
Perform the following guidelines to provide proper
performance for the machine.
•
Ensure that the brakes are burnished; refer to 3
Burnishing the Brakes (page 10) .
•
Check the fluid and engine-oil levels regularly.
Remain alert for signs that the machine or its
components are overheating.
•
After starting a cold engine, let it warm up for about
15 seconds before using the machine.
Note:
Allow more time for the engine to warm up
when operating in cold temperatures.
•
Vary the machine speed during operation. Avoid
fast starts and quick stops.
17