Toro 07059LT, Руководство оператора

Страница: 34 / 60

g192347
Figure 34
1. Spindle 2. Hub and rotor assembly
7. Wipe clean the spindle with a rag.
8. Repeat steps 1 through 7 to the hub and rotor at
the other side of the machine.
Greasing the Wheel Bearings
1. Remove the outboard bearing and bearing race
from the hub (
Figure 35 ).
g033050
Figure 35
1. Seal 4. Bearing cavity (hub)
2. Inboard bearing 5. Outboard-bearing race
3. Inboard-bearing race 6. Outboard bearing
2. Remove the seal, inboard bearing from the hub
(
Figure 35 ).
3. Wipe clean the seal and check for wear and
damage.
Note:
Do not use cleaning solvent to clean the
seal. Replace the seal if it is worn or damaged.
4. Clean the bearings and races, and check these
parts for wear and damage.
Note:
Replace all worn or damaged parts.
Ensure that the bearings and races are clean
and dry.
5. Clean the cavity of the hub of all grease, dirt,
and debris (
Figure 35 ).
6. Pack the bearings with the specified grease.
7. Fill the cavity of hub 50 to 80% full of the
specified grease (
Figure 35 ).
8. Assemble the inboard bearing onto the race at
the inboard side of the hub and install the seal
(
Figure 35 ).
9. Repeat steps 1 through 8 to the bearings for the
other hub.
34