Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
Cutting unit
1
Inspect the cutting unit.
2
No parts required
–
Use the kickstand when tipping the
cutting unit.
3
No parts required
–
Adjust the rear shield.
4
No parts required
–
Mount the counter weights.
Media and Additional Parts
Description
Qty.
Use
Parts Catalog
1
Operator's Manual
1
Review the material and save it in an appropriate place.
O-ring
1
Mount the reel motor to the cutting unit.
Screws
2
Mount the reel motor to the cutting unit.
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Inspecting the Cutting Unit
Parts needed for this procedure:
1
Cutting unit
Procedure
1.
Check each end of the reel for grease.
Note:
Grease should be visibly evident in the
reel bearings and internal splines of the reel
shaft.
2.
Ensure that all nuts and bolts are securely
tightened.
3.
Make sure the carrier frame suspension
operates freely and does not bind when moved
back and forth.
2
Using the Cutting Unit
Kickstand
No Parts Required
Procedure
Whenever you must tip the cutting unit to expose the
bedknife/reel, prop up the rear of the cutting unit with
the kickstand (supplied with the traction unit) to ensure
that the nuts on the back end of the bedbar adjusting
screws are not resting on the work surface (
5
