tornos SAS 16.6, Инструкция по эксплуатации

Страница: 16 / 46

300801_en - 12/12
1. Installation conditions - Instruction manual - SAS 16.6
1-8
1.4.3. Operating environment
1.4.3.1. Temperature and ambient humidity
Caution!
All devices are used within the tolerances not reaching and not exceeding the limits of their
operating specifications.
1.4.3.2. Noise
The purpose of the noise measurements is to determine the average sound levels where an
operator works most of the time.
The measurements take account of the following:
- a) sound power level,
- b) sound surface pressure level,
- c) Sound pressure level at the operator's workstation.
Attention!
If due to special reasons, the work station noise level (L
eq
) is 85 dB(A) or higher, the employer shall
provide useful information on the noise as well as hearing protection devices at work stations;
wearing these is recommended.
Specifications
Name
Unit Value
Maximum ambient humidity % 79
Room temperature of the workplace °C 5 - 35
Relative temperature °C +/- 15
Note!
The parameters which influence the real exposure levels include the duration of the operator's
exposure to noise, the shop characteristics, the other sources of noise, etc.
The values measured in the given conditions are those of the actual emission levels and make no
claim to conform to the safety-at-work levels.
Even though correlations between the noise emission and exposure levels exist, this noise
declaration report cannot serve as a basis for determining whether additional precautions are
required.
Any measurement results obtained on a particular production site, will obviously differ from those
measured by TORNOS SA at its plants.