298061_en - 07/12
1. Installation conditions - Instruction Manual - EvoDECO 10/10 & 10/8
1-12
1.7.
Machine connection to the barfeeder
1.7.1.
Description
The machine is always equipped with a bar guide (tube or barfeeder with push-rod).
The bar guide must be an independent machine unit with its own control. The control panel will be
positioned so that the manual bar guide controls are adapted to the machine.
1.7.2.
Necessary specifications
-
If possible machine bars with a diameter of Ø 1 to Ø 10 mm.
-
The maximum rotation speed must be 14000 min-1 (left / right).
-
The position of the end of bar sensor is set when the "MACHINE / BAR GUIDE" unit is installed, this
position cannot be changed, no matter what the length of the parts to be machined.
-
When the position or the end of bar sensor is enabled, the push rod must still be able to make a
stroke of at least 300 mm.
-
For a tube:
No preparation of the bar should be necessary to cover the entire range of capacity.
-
For a barfeeder:
No preparation of the bar should be necessary for bars with a diameter of Ø 1 to Ø 10 mm, and
remnant extraction should be from the back. When changing the bar, it is necessary to be able to
perform a "calibration" of it to position it a few mm outside the guidebush before the cut off in
order to avoid having to press against the cutting tool (shock).
Warning!
The space between the machine and the barfeeder must not allow a hand to pass, in order to
prevent any risk of accidents.
Warning !
An interface, defined by TORNOS SA, describes the functions that need to be performed by the
bar guide. This must be strictly complied with, in order to ensure perfect operation of the
"BARFEEDER - MACHINE" combination (poor operation of the barfeeding machine risks being
attributed to the machine).
The manufacturer of the bar guide is fully liable for its equipment in terms of current regulations in
the various countries and damage or accident where the cause is due to the bar guide.
Содержание EvoDECO 10/10
