tornos 199222-0017, Руководство по установке

Страница: 15 / 24

INSTALLATION − DECO 7e / 10e − 0017
300440 en − 01/07 Chap. 4.3 /5
4.2 FLOOR LOCATION
See Fig. 300.
− Do not level the machine (the floor to be level) :
It rests on three Support Plates D, two in the back and one in the front of
the machine.
− Anchor the machine in the floor with three screws by running them through
the holes in three Support Plates D.
The screws merely fix the machine to the floor and cannot support its
weight.
− Arrange a barfeeder according to its manufacturer’s recommendations.
− Take into account the dimensions of various options that you can attach to
the machine (bar feed tube, barfeeder, conveyor, etc.) because the floor
plan shows the basic machine equipment only.
4.2.1 Floor Preparation
See Fig. 300 and TRANSPORT INFO Sheet 300360.
The machine rests on three support plates.
The floor at these 3 points must be hard, stable, vibration-free and perfectly
level.
4.3 PACKING AND HANDLING FOR REMOVALS
When you move the machine within between your premises, follow the follow-
ing packing and handling requirements :
Note :
See TRANSPORT INFO Sheet 300360 and its Figures 1 to 3 in particu-
lar.
Packing and handling :
IN CASES (seaworthy packing)
− Run cords or chains through as marked.
ON PALLETS (under plastic)
− Pass packing needles of approx. 80 x 80 mm through Rectangular Pass-
ages B.
− Proceed with nailing on the road truck deck.
WITH FORK LIFT TRUCK or LOW LIFT TRUCK
− Pass the fork through Rectangular Passages A.
Fork length min.: 1100 mm
Note :
Before removing the lathe, clean it according to Para: PERIODICAL
CLEANING in your OPERATION & MAINTENANCE instructions.