Tormach Autofeed Bandsaw AF50, Руководство оператора

Страница: 58 / 90

11: TROUBLESHOOTING
©Tormach® 2020
Specifications subject to change without notice. Page 58 UM10538: Tormach AF50 Autofeed Bandsaw (Version 0320A)
For the most recent version, see tormach.com/support
11.1.7 Noise or Problems Moving Through the Cut
l
Problem The machine is loud while cutting, or it doesn't move freely while cutting.
l
Cause The feed rate may be too high, or you may be using the wrong blade.
You May Need
To...
Probability How-To Steps Need More?
Clean the
bandsaw.
High Examine the bandsaw for chip build-up between the
blade and it's wheels. If necessary, clean it of chips.
For information, see "Machine
Maintenance" (page 41).
Adjust the feed
rate.
High Verify that the feed rate isn't too high: lower the feed
rate, and then do a test cut. Examine the behavior of
the machine as it cuts.
For information, see "Change the
Feed Rate" (page 31).
Examine the
blade and the
material.
High Verify that the blade's TPI isn't too high, or that the
material isn't too course: you must use the correct
blade for the material. If you're not, you may need to
choose a new blade.
For information, see "Choose a
Blade" (page 28).
Adjust the
clamping
pressure.
Medium During automatic operation, verify that the clamp
pressure regulator isn't set too low: increase the
pressure, and then do a test cut. Examine the behavior
of the machine as it cuts.
For information, see "Change the
Clamping Pressure" (page 32).
Tighten the
handwheel.
Medium During manual operation, verify that the handwheel is
completely tightened. If it's not, tighten it.
For information, see "Manual
Operation" (page 37).
Adjust the
cutting speed.
Medium Verify that the cutting speed isn't too high: lower the
cutting speed, and then do a test cut. Examine the
behavior of the machine as it cuts.
For information, see "Change the
Speed" (page 31).