9.1 MACHINE SAFETY
Before operating the machine in any way, you must
read and understand this section.
Safe operation of the machine depends on its proper use and
the precautions you take. Only trained personnel — with a
clear and thorough understanding of its operation and safety
requirements — shall operate this machine.
9.2 MAINTENANCE SCHEDULES
To keep your machine running as smoothly as possible, you
must regularly do the following maintenance procedures.
Note:
Before you begin any maintenance procedures,
read and understand Maintenance Safety.
If you disassemble any components, refer to the machine's
reference drawings when you've completed the maintenance
procedure. For information, see "Diagrams and Parts Lists"
(page 69). For any additional support, we can help. Email
[email protected] to contact Tormach Technical Support
for guidance on how to proceed.
9.2.1 Daily
Clean the Blade Brush (PN 38033) of swarf.
Clean the drip pan of swarf.
Examine the drip pan grate for clogs.
Examine the coolant level and condition.
Use a rust inhibitor on all exposed, non-lubricated, non-
painted metal surfaces.
Note:
Don't use rust inhibitor on the guide rails
or vice lead screw.
Verify that the FRL Filter-Regulator-Lubricator has at
least 90 psi compressed air, and that the lubricator has
air tool oil above the bottom of the plastic tube.
9.2.2 Weekly
Clean all exterior surfaces with a mild cleaner.
Examine the blade brush and adjust it if it's not in
contact with the blade.
9.2.3 Monthly
Clean the electrical cabinet of dust with a clean cloth or
compressed air.
Clean fine swarf from the coolant tank.
Put #2 tube grease on each guide rail within the travel
path of the infeed table.
9.2.4 Semi-Annually
Note:
After the first 90 days of operation, complete
the items on this list. After that, complete the items
every six months.
Examine the motor belt for wear.
Lightly lubricate the vise lead screw with #2 tube grease.
Replace the gearbox oil.
9.3 REPLACE THE GEARBOX OIL
1. Power off the bandsaw and disconnect it from the main
air supply.
a. Push the Emergency Stop button on the operator
panel to lock it into the disabled position.
b. Turn the Main Disconnect switch to
OFF
.
Mains power is disconnected from the machine.
c. Disconnect the air line from your site from the input
port on the FRL Filter-Regulator-Lubricator.
2. Put a catch pan for the gear oil below the gearbox drain
plug.
3. Remove the four bolts from the gear box, and set aside
the cover plate and gasket.
4. Remove the drain plug and allow the oil to drain out.
5. Remove the remaining oil with a rag.
6. Install the drain plug and fill the gearbox with
approximately 10 oz (0.3 liters) of SAE 90 Gear Oil (ISO
220).
7. Replace the cover plate and gasket, and secure them in
place with the bolts that you set aside in Step 3.
©Tormach® 2020
Specifications subject to change without notice.
Page 42
UM10538: Tormach AF50 Autofeed Bandsaw (Version 0320A)
For the most recent version, see tormach.com/support
9: MACHINE MAINTENANCE
