TECHNICAL DOCUMENT
BEFORE YOU BEGIN
1. If there's a tool holder in the spindle, remove it.
2. Remove any accessories or fixtures from the machine table.
3. Center the machine table: from the PathPilot interface, in the
MDI Line
DRO field, type
G20 G53 G1 X7
Y-3.75 Z0 F20
. Then select the
Enter
key.
IMPORTANT!
You must update your controller to the latest version of PathPilot before installing and
operating the Automatic Tool Changer. If you don't, there's a risk that the ATC could become
inoperable.
4. Update your controller: From the
Status
tab, select
Update
. Then, follow the on-screen instructions. Once
the controller is updated to the latest version of PathPilot, go to Step 5.
WARNING!
Electrical Shock Hazard: You must power off the machine before making any electrical
connections. If you don't, there's a risk of electrocution or shock.
5. Power off the machine and the PathPilot controller.
a. Push in the Emergency Stop button on the operator box, which removes power to motion control.
b. From the PathPilot interface, select
Exit
.
c. Turn the Main Disconnect switch to
OFF
on the side of the electrical cabinet.
Page 3
©Tormach® 2020
Specifications subject to change without notice.
tormach.com
TD10627: Owner's Guide: 770MX Automatic Tool Changer (ATC) (1220A)
