Tormach 1300PL, Руководство оператора

Страница: 54 / 100

F225 (Set cutting feed rate of 225 IPM)
G15 (Perform ohmic probe)
G16 (Pierce and start cutting)
The block of code shown above is totally valid and can be used
if you prefer to hard code your cutting parameters.
Alternatively, the code shown above can be replaced with the
following when AutoFS is being used:
M200 (Set cutting parameters from AutoFS tables)
G15 (Perform ohmic probe)
G16 (Pierce and start cutting)
6.3.2 Using AutoFS
Before running your program, select the material you are
cutting from the AutoFS dropdowns on the main tab of
PathPilot.
The DROs turn green, which indicates that they were
automatically set.
With a material selected, the next time an
M200
code is
encountered in a program, PathPilot will set all of the cutting
parameters for that material.
6.3.3 Creating new AutoFS Presets
Since your shop air supply and cutting conditions might differ
from those used to create the AutoFS presets, you can save
your own custom settings for a material at any time.
To create new AutoFS presets:
1. Select the material you are using like normal from the
dropdown menus, and then type your new cut
parameters into the DRO fields.
2. Select Save .
The values are stored as a new preset for that material.
©Tormach® 2020
Specifications subject to change without notice. Page 54 UM10720: 1300PL Operator's Manual (Version 0820B)
For the most recent version, see tormach.com/support
6: BASIC OPERATIONS