Tormach 1300PL, Руководство оператора

Страница: 38 / 100

10. Verify that the blue Reset LED on the operator box
comes on. From the PathPilot interface, on the Status
tab, verify that the Machine OK light changes from
yellow to green.
Once both are on, the machine is powered on and ready
to operate.
Figure 4-5: Machine OK light on the Status tab.
11. Select Reset .
Figure 4-6: Reset button.
4.12.3 Power Off the Machine
1. Push the Emergency Stop button on the operator box to
lock it into the disabled position.
Figure 4-7: Example of the Emergency Stop button
locked in the disabled position.
With the Emergency Stop button in the disabled position
all motion function stops, and the Reset button is
disabled. On the operator box, the blue Reset LED goes
off. From the PathPilot interface, on the Status tab, the
Machine OK light goes off.
2. From the PathPilot interface, select Exit .
3. When prompted, select OK .
4. Turn the Main Disconnect switch to OFF .
Figure 4-8: Example of the Main Disconnect switch in
the Off position.
Mains power is disconnected from the machine.
4.12.4 Verify Axes Function
You must confirm that the axes correctly operate.
1. Power on the machine and bring it out of Reset.
2. Reference the axes: from the PathPilot interface, select
Ref Z , Ref X and Ref Y .
Figure 4-9: Ref Z, Ref X, and Ref Y buttons.
The machine moves to the reference position.
3. Use the keyboard to verify axes motion:
l
Select the Right Arrow key and then the Left Arrow
key.
The torch carriage moves right (X+), then left (X-).
l
Select the Up Arrow key and then the Down Arrow
key.
The gantry moves toward the back end of the table
(Y+), then toward the front (Y-).
l
Select the Page Down key and then the Page Up key.
The torch lifter moves down (Z-), then up (Z+).
©Tormach® 2020
Specifications subject to change without notice. Page 38 UM10720: 1300PL Operator's Manual (Version 0820B)
For the most recent version, see tormach.com/support
4: INSTALLATION