Band switch
d
escription for TS0S5
-01-
-02-
-03-
OCCUPANCY SENSOR SWITCH
Figure 2
Figure 3
TSOS5 /TWOS5
TSOS5
TSOS5
TWOS5
INSTALLATION INSTRUCTIONS
TWOS5
1.
Connect lead wires as WIRING DIAGRAM (see Figure 2): Black lead to
Line(Hot), Red lead to Load wire, White lead to Neutral wire, Green lead to
Ground.
2.
Gently position wires in wall box, attach sensor switch to the box.
3.
Mount device “TOP”up.
4.
Restore power at circuit breaker or fuse, wait
one minute.
5.
Remove the small cover plate. (Illustrated as Figure 3. )
6.
Locate the adjustment knobs on the control panel to perform test
and
adjustment.(Illustrated as Figure 3. )
7.
Replace the small cover plate after testing and adjustment.
8.
Attach the wallplate.
Time Delay knob
Default position: 15 Seconds (Test mode)
Adjustable: from 15 Seconds to
Turn toward left to avoid false alert in smaller room and near
the door way or heat source.
Ambient Light Level Knob
Default position: Daylight (100% at position 4)
Adjustable: Daylight to 30Lux (Counter clockwise)
Note: to avoid wasting energy by turn-on the light under daylight.
30 Minutes (clockwise)
Sensor Sensitivity Range Knob
Default position: Center at 65%
Figure 4
Adjustable: 30% (Position 1) to 100% (Position 4)
Note: Turn toward right for greater room space.
Press
OFF
Figure 5
Press and release
AUTO
Figure 6
The passive infrared sensors work by detecting the difference between
heat emitted from the human body in motion and the background space.
The sensor switch can turn a load on and hold it as long as the sensor
detects occupancy. After no motion is detected for the set time delay, the
load turned off automatically. The sensor switch has one relay (equal to
single pole switch), also includes Ambient Light Level Sensor.
AUTO
Mode
OFF
ON
Description
Circuit is permanently opened.
Position
Left
Center
Right
Load stays On always.
(switched off)
Occupancy Mode:
Automatic On when occupancy is detected.
Automatic Off after the set time delay.
Push-button for TWOS5
As illustrated in Figure 5, the Load stays Off when the button is
pushed in and locked. (switched Off)
Figure 1
S
PECIFICATIONS
Switch Type...................................................................................Single Pole
Voltage................................................................................…..120VAC,60Hz
Fluorescent........................................…..........................................
..
..…500V
Motor ................................................................................................…1/8Hp
Incandescent .........................................................................................500W
Time Delay .....................................................….................15Sec to 30Mins
Light Level.............................................................................30 Lux--Daylight
Operation Temperature.......................................................
.
....... 32 F--131 F
D
ESCRIPTION
Coverage Area
The coverage
range of the sensor switch is specified and illustrated in
Figure 1. Large objects and some transparent barriers like glass
windows will obstruct the sensor's view and prevent detection, causing
the light to turn off even though someone is still in the detection area.
SAFETY WARNING:
:
Read and understand these instructions
before installation. This device is intended for installation in
accordance with the National Electrical Code and local
regulations.
I
t is recommended that a qualified electrician
perform this installation. Make sure to turn off the circuit
breaker or fuse(s) and test that the power is off before wiring
the device.
Note:
Please check
the
junction box for a neutral wire. This switch
requires a neutral wire in the junction box for it to work properly.
W
iring Diagram
:
INSTALLATION
ADJUSTMENT
OPERATION
