Topens MT9012, Руководство пользователя

Страница: 19 / 32

16
Motor connection for PULL-TO-OPEN
Actuator 1 (for PULL-TO-OPEN)
Insert the stripped cable wires into the appropriate terminals on the opener terminals block. The red wire
should be inserted into the “ ” terminal, the black wire into “ MOTOR1-“ , the blue wire into ULT1 , the
green wire into COM , and the yellow wire into DLT1 terminal.
Actuator 2 (for PULL-TO-OPEN)
Similar as the connection of Actuator 1 , insert the stripped cable wires into the appropriate terminals on the
opener terminals block. The red wire should be inserted into the terminal, the black wire into
MOTOR2- , the blue wire into ULT2 , the green wire into COM , and the yellow wire into DLT2 terminal.
NOTE: It is recommended that Gate Opener 1 is installed in the Master Gate, and Gate Opener 2 is installed in
the Slave Gate.
Warning Light (Included in some models, refers to the actual package)
The red wire of the warning light should be inserted into +LAMP (#11) terminal, the white wire into the LAMP-
(#12)
.
Back-up Battery & Solar Panel & Solar Controller (optional)
If there is no solar panel to be used for charging the battery, then the “24V+” of the battery should be wired to
the BAT+ (#13) terminal. “24V-” should be wired to “BAT-” (#14) terminal.
The battery could also be charged by the solar panel & solar controller. Please refer to the manual instruction of
solar panel and controller separated for wire connection.
Photocell Beam System (PBS)
(Included in some models, refers to the actual package)
Use a 2-core cable to connect the “- ~” terminal of the photocell’s emitter to the “14” terminal, the “+ ~” terminal
to the “9” terminal. Also the “- ~” and “+ ~” terminals of the photocell’s receiver should be connected to the “14
and “9” terminals in parallel.
Use another 2-core cable to connect the
“COM” terminal of the receiver to the “17” terminal, the “NC” terminal
to the “18” terminal.
Push Button (optional)
The push button should be wired to the “19” and “20” terminals. The gate operator works alternately by pushing
Motor connection for PUSH-TO-OPEN
The motors’ power wires and limit wires connection by
“Push to Open” is different from the connection by “Pull
to Open” . So motor 1 and motor 2 wires should be
connected to the control box as the instruction on the right.
The
black wire should be inserted into the Motor+ terminal,
the
red
wire should be inserted into the Motor- terminal, the
yellow wire into ULT1 terminal, the blue wire into DLT1
terminal and the green wire is still into COM terminal.