Topcon TRK-2P, Руководство пользователя, Страница: 51 / 118

49
BASIC OPERATIONS
BA
SI
C OPERATIONS
PRINT-OUT O
F
M
EASUREM
ENT
VAL
UES
PRINT-OUT OF MEASUREMENT VALUES
This instrument can print out measurement values with a printer.
1
Check that the Measurement screen is on.
2
Tap the button on the control panel.
Measurement values on the monitor are printed out.
END OF MEASUREMENT
Tell the patient a measuring is end and leave from the instrument.
NOTE
• To avoid a paper jam in the printer, do not feed the paper if it is partly cut
or wrinkled.
• To avoid discoloring of the printer paper (particularly the recording area)
during storage, use a polypropylene bag and not one containing plasti-
cizer (PVC, etc.).
• To avoid discoloring of the printer paper (particularly the recording area)
after pasting, use water-soluble glue and not one containing solvent.
• Since the printer paper is thermosensitive, it is not suitable for keeping
records for a long period. If necessary, prepare copies separately.
NOTE
• When a red line is printed at the edge of the printer paper, replace it with a
new one. For details about the replacement of the printer paper, see
PRINTER PAPER SETTING on page 27. 58mm wide printer paper
(example: TP-50KJ-R, Nippon Paper) is recommended.
• When the "Auto print" is set to "ON" in the "Common" of the "Initial", mea-
surement is performed under Auto mode, and measurement results are
printed out automatically. (See page 84.)
• When the "Auto cut" is set to "OFF" in the "Common" of the "Print" and
you need to cut a printer form, the way is that erase the measurement
value by tapping the button, and tap the button to
cut.
• When the print out button is tapped again after all the data is cleared by
printing out the measuring data, the previous measuring data is printed
out.
Print out
0#/'
6101&#6#
ޛ4
ޜ
OO*I#&,OO*I#&,
AA#/
1+&-GPL[CA
0Q
-GPL[CA 50
%6
'44
#8)
#8)
#8)
'44
'44
'44
'44
'44
'44
'44
ޛ.
ޜ
ޛ4
ޜ
ޛ.
ޜ
J2C#&,
J2C#&,
2#%1&#6#
612%10
/GUUCIG
4 OO
. OO
All clear Print out