22
6. BASIC OPERATION
After setting the grade value, set the laser line.
Use [Left] key and [Right] key to set the laser line.
The maximum adjusting range is 9 m (29.5 ft.) at a distance of 30 m (100ft.)
The speed of the line travel is variable. When the key is first pressed, the speed will be slow.
By pressing the key continuously, the speed of line travel will increase.
The relative position of the laser beam is shown on the display as indicated below.
1. By pressing the [Right] or [Left] key, move the horizontal laser position to the right or left required.
• Setting Laser Line is not possible when the instrument is locked.
When operating through RC-500
1. Make sure that the basic screen is indicated on the TP-L6W.
2. In order to emit the laser beam correctly to the reference point of laser line, press [Laser right/left]
keys of the remote controller RC-500 and move the laser emission position horizontally.
For the details of RC-500, refer to the following chapter.
"8.2 Remote Controller (RC-500 )" (p.43)
6.3
Setting Laser Line
This display indicates that the laser line is
positioned at the right end of the
adjustment range. The laser line will not
travel to the right even if the [Right] key is
held down. In addition, the laser will blink
to alert the user of this condition. It is
always a good idea to pre-position the
laser to the center of its adjusting range
prior to setup.
This display indicates that the laser line is
positioned at the left end of the
adjustment range. The laser line will not
travel to the left even if the [Left] key is
held down. In addition, the laser will blink
to alert the user of this condition. It is
always a good idea to pre-position the
laser to the center of its adjusting range
prior to setup.
LASER LINE INDICATOR
Maximum line adjust range
Right key
Left key
Laser right/left key
